liftmaster keypad programming no enter button

#Liftmaster keypad programming no enter button code

Open cover fully by sliding keypad cover up until it latches.To Program the Intellicode Wireless Keypad Indicator light will blink once and go out.

Press and hold “PROG” and “8” while fully opening cover.

GWKIC, ACSDG, Two Part, Step-By-Step Programming Model 1: Intellicode Model GWKIC, ACSDG ( black with slide-up cover and the word “Intellicode” printed on the cover) Genie Wireless Intellicode Keyless Entry Pad Programming: 3 Models

Test Keypad by sliding cover up until it latches.

Enter Door Code, as determined from the chart above, and press the “star” key.

Your PIN number can be created from any group of numbers up to 8 digits of your choice.

Enter your PIN and press the # button.

Press 3, 5, 7 and # buttons in said order.

If the back lit keypad light goes out, close the cover pad and reopen it until it clicks. At this point, if the back lit keypad light stays on, proceed directly to step 2. While pressing the # and 8 buttons simultaneously, slide the Keypad Cover the rest of the way up until it latches.

Reset Keypad–slide keypad cover half way up.

You can then print out a legible copy of the chart and the programming instructions from your word software. To make a copy, highlight area and copy into your word program.

#Liftmaster keypad programming no enter button code

You should have 3 or 4 Door Code numbers. Continue with the next 3 switches and its corresponding number, and so on, until the last set of 3 switches. Determine the settings of the first 3 switches and write down the corresponding number from the chart. The Door Code in the Step-By-Step Procedure at right is determined by the internal code switches inside your transmitter and the accompanying chart. It is NOT compatible with Genie Intellicode transmitters (if your keypad has Intellicode printed on the cover, go to the next set of programming instructions below). This keyless garage door opener entry pad works with Genie transmitters using 390 MHz frequency.

Keypad is black with a slide-up cover showing the Genie logo only) ( works with remotes having 9 or 12 internal code setting switches. Outside Keypad Programming Genie Garage Door Opener Keypads Genie Garage Door Opener Wireless Keypad Model GPWK-12, GWK

Gadgets & Miscellaneous Garage Door Opener Parts.

Liftmaster / Chamberlain Outside Touchpads.

Sears / Craftsman Compatible Miscellaneous Parts.

Sears / Craftsman Compatible Infra-Red Sensors.

Sears / Craftsman Compatible Outside Keypads.

Sears / Craftsman Compatible Remote Controls.

Liftmaster / Chamberlain Miscellaneous Parts.

Liftmaster / Chamberlain Infra-Red Sensors.

Liftmaster / Chamberlain Outside Keypads.

Liftmaster / Chamberlain Remote Controls.